Musica edin torni

About 2 years ago, when maytag washing machine repair manual pdf nearly 10 years of uninterrupted service our trusty Fisher and Paykel GW609 washing...

About 2 years ago, when maytag washing machine repair manual pdf nearly 10 years of uninterrupted service our trusty Fisher and Paykel GW609 washing machine failed to start I wasn’t sure what to do. Should I buy a new one?


Or should I try to repair it and in the process, save the environment of more plastic, lead, and who knows what else? I felt that at least I should give the repair a go. And so I began searching the Net for schematics, technical info and anything helpful I could find.

But very little was forthcoming. Only a few posts here and there but nothing substantial, the general consensus were that most of the faults are to do with the Control Module. Control Module or its schematic.

It seems no one had been able to repair the Module and that this part is considered a throwaway by the manufacturer when faulty, to be replaced with a new one when it fails. This seemed like a waste of natural resources and money and so I decided to take a good look at it and check it, to see if it was really faulty and if so, could be repaired.

UNPLUG THE MACHINE BEFORE OPENING THE CONTROL PANEL ! During the repair, always double check and take a look at that plug to make sure it is off the wall before doing anything inside the machine. Yes, here we are going to deal with possible electrocution if you are careless because the control board and peripherals are all connected to mains.

Make sure the plug is off the wall. It is convenient if the washing machine is empty of water and washing because the water level sensor will not be affected when it is disconnected, and latter on re-attached, during the repair. The Control Panel is connected to the Control Module by a cable with a plug.

Disconnect this plug from the module and put the Control Panel aside in a safe place. Step 3: Removing the Control Module.

At this point, if you have a Digital Camera handy, take one or two photos of the whole thing and keep it for reference later on, when re-attaching everything back. Do not pull from the hose as this will grab the sensor’s plastic pipe and possibly break it! Take care, as the hose will most probably be stuck to the sensor by years of close contact. Next, unplug the spade connectors on the top-left corner noting their positions.

This is very important because they are the mains and the ground connections and these must go back to the exact same locations. With everything disconnected from the Module, remove the screw that secures the Module to the machine and lift it clear off the machine.

admin